Using the HP DTC 16RX Manager

60
Configuring SNMP authorization filters
8
1 Type the following command at the system prompt:
rdtcmodify dtcname
The DTC Rear Panel Configuration screen appears.
2 Enter L or l in the board field of the Rear Panel Configuration screen.
3 Press the Action Menu (F5) function key for a list of action options.
4 Select Configure SNMP Authorization Filters and press the Select Action
(F4) function key. Refer to the online help when entering data in the screens.
5 When you have finished entering values, press the Perform Task (F4) function
key. You return to the Rear Panel Configuration screen.
6 You must perform a disruptive reset the DTC to modify the SNMP parameters.
Press the Exit Task function key to leave the DTC Manager menu-driven user
interface. You are asked several questions to confirm your configuration. To
activate your changes you can either:
• Type y to the question: Do you want to reset the DTC 16RX now?
or
• Type the following command later at the prompt:
rdtcreset <dtcname>
The SNMP authorization filters parameters
SNMP Manager IP
Address
Enter the IP address of an SNMP manager that can monitor and control the DTC as
an SNMP network element.
A value of 0.0.0.0 in this field means that any SNMP manager that has the same
community name as the community name corresponding to this IP address can
access this DTC’s MIB parameters.
The IP address 255.255.255.255 is not valid in this field.
SNMP Manager
Community Name
Enter the name of the SNMP community to which the DTC belongs.
All ASCII characters are valid in this field.
If two SNMP authorization filters have the same SNMP manager community name
they must also have the same MIB access and MIB view values.