Using the HP DTC 16RX Manager

50
Configuring global parameters
7
When the DTC encounters a serious problem, it will automatically transfer
information to the DTC Manager. This information is called a software upload.
When short uploads are enabled, the DTC sends the upload reason and the last DTC
events to the DTC Manager instead of a complete upload. Other information on the
upload is not sent.
By default, complete upload files are sent to the DTC Manager.
Upload IP Address Enter the IP address of a local system in this field so that DTC uploads are sent to a
local system rather than to the DTC Manager. This avoids causing heavy traffic on
your network, especially if the DTC is connected to the DTC Manager by low-speed
links.
Only use this field if instructed to do so by your Hewlett-Packard representative.
By default (Upload IP Address = 000.000.000.000), upload files are sent to the
DTC Manager.
Enable DTCDF Access Enter an X or an x in this field to enable the Hewlett-Packard customer response
center to access DTC memory in case of problems. Access to your DTC is protected
by a password which is defined in the DTCDF password field.
By default the Hewlett-Packard customer response center can not access your
DTCs.
DTCDF Password Enter up to 8 alphanumeric characters in this field. The first character must be
alphabetic and all alphabetic characters must be entered in upper case.
This field contains the password which you must give to your Hewlett-Packard
representative to enable the Hewlett-Packard customer response center to access the
DTC’s memory for troubleshooting.
The default password is AVESTA (upper case).
Enable RAFCP Front
End
If you intend to use the DTC as a Routable AFCP gateway, you must put an x or X
in this box. You must also go to the DNS/IP window and provide the IP addresses of
the Domain Name Servers and routers that you intend to use. If you modify this
parameter you must reset the DTC.