Using the HP DTC 16RX Manager

Conﬁguring the LAN board parameters

Configuring the LAN board parameters

You must conﬁgure the LAN Board if you want to change any of the following

parameters:

• IP and DNS Parameters, which include:

• DTC IP Address

• DTC Node Name

• DNS server addresses

• Global Parameters, which include:

• DTC user interface timeout, user prompt and welcome message

• Parameters related to DTC uploads and formatting upload information

• RAFCP Front End capability

• TCP Parameters: TCP timers that may need to be altered for extended LAN

configurations

• AFCP Parameters: timers that may need to be adjusted for extended LAN

configurations with HP 3000 systems.

• SNMP Authorization Filters which identify your network's SNMP

management nodes, the information that these nodes can request and the rights

of access to the SNMP MIB data (see “Configuring SNMP Parameters” on

page 57).

• SNMP Parameters which define the SNMP-specific data to be stored on the

DTC (see “Configuring SNMP Parameters” on page 57).

Configuring a DTC LAN board

The steps for conﬁguring the LAN board from the Rear Panel Conﬁguration

screen are explained below.

1 Type the following command at the system prompt:

rdtcmodify dtcname

The Rear Panel Conﬁguration screen appears. This screen represents the rear

of the DTC and is the starting point for all DTC conﬁguration procedures. The

DTC Rear Panel Conﬁguration screen is shown in ﬁgure 2.

2 Enter L or l in the board field of the Rear Panel Conﬁguration screen.