Using the HP DTC 16RX Manager

Resetting a DTC

Most of the DTC parameters are dynamic—they can be changed while the DTC is

operational. However, if you change any of the parameters described below, you

must reset the DTC. This is because the parameters are static. Changes to the

parameters can not be activated while the DTC is operating. A reset is disruptive and

breaks any active sessions.

You can modify any of the following parameters:

• DTC node name

• DTC IP address

• TCP timers

• AFCP timers

• SNMP parameters

• Port group settings (modem or direct connect)

• RAFCP Front End capability.

If you modify either of the following two parameters you must also modify them on

DTC (at the DTC’s console).

• DTC node name

• DTC IP address

When you modify DTC parameters, at the end of the conﬁguration process you are

prompted to activate your changes immediately. You can also choose to reset the

DTC later and activate your changes at a more convenient time for you.

Resetting a DTC

There are two ways to reset the DTC and start a conﬁguration download:

• Turn off and turn on the DTC

• Run the rdtcreset dtcname command.