Using the HP DTC 16RX Manager

38
Accessing and using the Rear Panel Configuration screen
6
Accessing and using the Rear Panel Configuration screen
1 Type either of the followings command at the system prompt:
rdtcmodify <dtcname>
or
rdtcmodify <IP_address>
The DTC Rear Panel Configuration screen appears. This screen represents the
rear of the DTC and is the starting point for all DTC configuration procedures.
The DTC Rear Panel Configuration screen is shown in figure 2 and shows a
DTC named claudia that was created in DTC version A143000.
Figure 2. Rear Panel Configuration screen
The following tasks can be performed at the Rear Panel Configuration screen:
• Configuring global DTC parameters on the LAN board.
• Changing a port group to modem or direct connect.
• Copying and pasting the configuration of all the ports of a DTC simultaneously.
• Changing port type and configuring ports.
• Copying port configurations within a DTC or to another DTC.