Using the HP DTC 16RX Manager

34
Checking terminal connections
4
Checking terminal connections
Follow these steps for each terminal connected to the DTC.
1 On the terminal, press the Return key. The DTC prompt, usually DTC>, should
appear. Use one of the following connect commands:
DTC>connect IP_address
DTC> c name
The parameter IP address
*
is the IP address of the system you want to
connect to. The parameter name can be an HP 3000 node name, a DTC host
port name or an Internet Service name.
You are then connected to the specified system and see the message.
Connection #1 established to mysystem.mygroup.mycorp
To return to DTC interface, type <CTRL>K
2 If you are not successful, try to modify the configuration of the DTC
(“Modifying a Configuration” ). If the DTC does not respond, it probably means
that the dtcname or DTC IP address does not correspond exactly to the
information entered in the Network Information screen of the DTC. See
page 46 to change the DTC IP address.
3 Check the Rear Panel Configuration screen to see the DTC name, for example
on page 43 the DTC name is claudia. If the DTC name does not correspond to
the DTC name you entered on the DTC itself, delete the DTC, then add it again.
For more information, “Deleting DTCs” .
4 If you still cannot establish a connection, go to the troubleshooting section
starting on page 113, to obtain more help.
* You can only use a system name to connect to a Telnet system if you have configured the system
name in the DNS server.