Using the HP DTC 16RX Manager

Hardware requirements

Ensure that you have the following hardware:

• An HP 9000 Series 700 or 800.

• LAN/9000 LINK hardware components including the LAN interface card

(LANIC).

• A terminal connected to a MUX on your system (you can run DTC Manager

from a terminal, a workstation or a remote X terminal).

• At least 24 Mbytes of free disk space to install the DTC 16RX Manager

software.

• Additional disk space depending on the number of DTC 16RXs, and how much

room you want for upload files during troubleshooting (you can run DTC

Manager from a terminal, a workstation or a remote X terminal).

• You will need 1.5 Mbytes for each DTC 16RX managed. You will need

2.2 Mbytes to upload a file from a DTC 16RX (you can run DTC Manager from

a terminal, a workstation or a remote X terminal).

Software requirements

Ensure that you have the following software installed and operational on your

HP 9000 Series 700 or 800:

• HP-UX. release 9.X or 10.0

• Internet Services

• tftp (see chapter 3)

Supported terminals

The following terminals are supported with the DTC 16RX Manager:

• HP compatible terminals with programmable function keys and on-screen

display of function key labels

• HP terminals with ASCII mode

• Wyse-30, Wyse-50 and Wyse-60 terminals