Using the HP DTC 16RX Manager

152

DTC terminal parameters

The following parameters are related to the DTC terminal user interface.

Switching Only terminals which have switching enabled are connected to

the DTC terminal user interface. If switching (see page 78) is

disabled, from a terminal you are connected directly to the

system and do not see the DTC prompt.

Welcome message This message is displayed when you try to logon from a

terminal or when you use the Status command. The welcome

message is explained on page 49.

User prompt This prompt is displayed when you try to logon from a terminal.

It is at the user prompt that you enter the DTC terminal user

commands. The user prompt is explained on page 49.

Escape from data transfer

character After connecting to a system, you can return to the DTC

terminal user interface by using the Escape from Data Transfer

character. The default is Ctrl-K (^k). If you are in binary mode

(See the “Set Binary” command on page 154), use the Break

key. The escape from data transfer character is explained on

page 89.

Default destination If a default destination system has been deﬁned for the port,

then you can enter the DTC connect command without

specifying a system. You are automatically connected to the

default destination system.

DTC user interface commands

Type help at the DTC prompt to see a list of the available terminal user commands.

The following commands are available at the DTC user interface:

• connect

• disconnect

• help

• logout

• recall

• set ascii

• set binary

• status