Using the HP DTC 16RX Manager

138

About the command

With rdtcmodifyconfs you can:

• Modify DTC configurations that were created with rdtcadd

• Copy data from one configuration and paste it into another (except

LAN board configurations)

• Modify parameters with a script.

Note The rdtcmodifyconfs command can only be used to modify DTCs that already

exist—it cannot be used to create a DTC. To create a DTC configuration, use the

rdtcadd command.

You must download the new conﬁguration to the DTC whenever you change any of

the following SNMP parameters:

• contact name

• sys name

• sys location

• SNMP enable authentication traps

• trap destination IP address.

There are two ways to reset the DTC and start the download:

• Turn off and turn on the DTC

• Run the command rdtcreset dtcname.

Using rdtcmodifyconfs

The rdtcmodifyconfs command enables you to modify multiple DTC

conﬁgurations by creating a shell script containing the desired parameter settings for

each DTC.

You must have superuser privileges. To execute rdtcmodifyconfs commands,

logon as root or enter the su (superuser) command.