Using the HP DTC 16RX Manager

125

Commands an HP engineer might ask you to use

The rdtcping command helps you:

• Do a preliminary connectivity check when setting up the DTC connections

• Do a quick check of the connectivity if the response from a DTC seems

unusually slow.

You must run rdtcping as superuser. The rdtcping command can be scheduled

using the HP-UX at command or the HP-UX cron command. Only one rdtcping

or other diagnostic command can be run at a time.

rdtcping dtcname

Example

Perform dtcping on the DTC called mydtc:

rdtcping mydtc

Commands an HP engineer might ask you to use

Caution Only use the following commands if instructed to do so by an HP engineer for

troubleshooting purposes.

The information uploaded to the DTC Manager during a DTC upload can only be

read with special formatting tools available only to HP engineers.

Turning off or turning on an extended trace

The rdtctraceoff command turns off an extended trace for the selected port.

rdtctraceoff dtcname dtcport

The rdtdctraceon command turns on an extended trace for the selected port.

rdtctraceon dtcname dtcport

Examples

To turn on an extended trace for port 0 of the DTC named dtc3:

rdtctraceon dtc3 0