Using the HP DTC 16RX Manager

111
Configuring a DTC printer for the HP-UX spooler
15
ocd-start ()
{
ddp ddfa/dp -k
}
....
case $ State in
standalone )
...
net-start
ocd_start
...
;;
Configuring a DTC printer for the HP-UX spooler
The printer on the DTC must be specified with the HP-UX spooler using the System
Administration Management (SAM) tool or the HP-UX lpadmin command. Refer
to the HP-UX System Administration Tasks Manual for information on the HP-UX
printer spooler.
Configuring a printer using SAM
Configure an HP-UX spooler from SAM as follows. These procedure is for HP-UX
9.0 used on an HP 9000 Series 800 system and may vary slightly for different
versions of HP-UX.
1 Select the following menu options (starting from the SAM main menu).
a Choose Printers/Plotters.
b In the Printer/Plotter Manager screen, choose:
Actions -> Local Printer Plotter
If you are using a character mode terminal the menu bar (F4 Menu bar On/Off)
must be on to use the Actions option.
c Choose Add Printer/Plotter Requiring Nonstandard Device File.
2 Complete the Add Printer screen as follows:
Printer name:
Assign a name to the printer.
Printer model/interface:
With this field selected, press the Enter key. Choose the printer model
corresponding to your printer from the list of printer models displayed.
Printer device file name: