Using the HP DTC 16RX Manager

101

Conﬁguring the HP 3000 with NMMGR

Configuring the HP 3000 with NMMGR

The following tasks must be performed on the HP 3000 Series 900 to support

connections via a DTC.

• Configure DTS information on the HP 3000 Series 900, such as the

HP 3000 Series 900 node name, the link name, and the physical path of the

LANIC.

• Configure the maximum number of non-nailed terminals that can log on to the

HP 3000 Series 900 at one time.

• Configure information about each DTC that will communicate with the

HP 3000/900, including its name, and the node name (the LAN address is also

necessary for nailed devices).

• Configure DTC port information for each nailed terminal.

• Ensure that the following parameters match:

• The HP 3000 Series 900 node name

• The DTC node name.

Configuring a printer for access by an HP 3000 system

This procedure summarizes how to conﬁgure a printer on the DTC for access by

HP 3000 systems. There are three major steps:

1 Configure a DTC port to be a printer port:

• See chapter 10, "Changing Port Type to Terminal, Printer or Host" to

change the port type to printer.

• See chapter 11, "Configuring Terminal, Printer and Host Ports" to set the

other port parameters.

2 Configure the printer on the HP 3000—refer to Conﬁguring Systems for

Terminals, Printers and Other Serial Devices.

3 Test that you can print.