Using the HP DTC 16RX Manager

8
Manual organization
names
• Knowledge of the operation of the HP DTC 16RX and the devices connected to
it.
Manual organization
This manual is organized as follows:
Chapter 1—Introduction to DTC Manager briefly describes the
DTC 16RX Manager product and the DTC 16RX.
Chapter 2—Before Installing DTC Manager Software describes the hardware
and software requirements.
Chapter 3—Installing the DTC Manager Software describes how to install the
DTC 16RX Manager software.
Chapter 4—Adding DTCs describes how to add a DTC 16RX to your
configuration and configure it with the default configuration.
Chapter 5—Deleting DTCs describes how to delete a DTC from the list of DTCs
managed by DTC Manager.
Chapter 6—Modifying a Configuration describes how to modify the
configuration of a DTC using the command rdtcmodify.
Chapter 7—Configuring a LAN Board describes how to configure the global
DTC parameters.
Chapter 8—Configuring SNMP Parameters describes how to configure a DTC
for Simple Network Management Protocol (SNMP) access.
Chapter 9—Changing a Port Group to Modem or Direct Connect describes how
to change the port group type on the DTC Manager.
Chapter 10—Changing Port Type to Terminal, Printer or Host describes how to
set the port type for connections to terminals, printers or host computers.
Chapter 11—Configuring Terminal, Printer and Host Ports describes how to
configure individual ports on the DTC.
Chapter 12—Copying and Pasting Configurations describes how to copy DTC
board and port configurations within a DTC and from one DTC to another.