User's Guide for MS-DOS Clients

347
Using Remote Access Service
Configuration Files
Configuration Files
During installation, the RAS Setup program modifies existing MS-DOS and
LAN Manager configuration files to enable or to optimize performance. For
MS-DOS and Windows client workstations, the RAS Setup program
modifies the CONFIG.SYS, LANMAN.INI, and PROTOCOL.INI files.
CONFIG.SYS
The RAS Setup program adds the following lines to an MS-DOS client’s
CONFIG.SYS file:
DEVICE = C:\LANMAN.DOS\DRIVERS\ASYNC\ASYMAC\ASYMAC.DOS
If necessary, the Setup program also adds the MS-DOS protocol manager,
PROTMAN.DOS, to the device list. This line is in the form:
DEVICE = lC:\LANMAN.DOS\DRIVERS\PROTMAN\PROTMAN.DOS /i:lanroot
LANMAN.INI
The RAS Setup program modifies the wrkheuristics and wrknets entries of
the [workstation] section as follows:
wrkheuristics = xxxxxxxx00xxxx1xxxxxxxxxxxxxxxxxxx
wrknets = netx, nety,...
PROTOCOL.INI
The RAS Setup program adds the following lines to the client's
PROTOCOL.INI file:
[ASYBEUI_XIF]
DRIVERNAME = ASYBEUI
BINDINGS = "ASY_NIF", "ASY_NIF2"
LOAD = ASYBEUI,VCOMMIOD[U],WANTSR[U]
UNLOAD = "WANTSR /U[C]","VCOMMIOD /U[C]", "ASYBEUI[D]"
[ASY_NIF1]
DRIVERNAME = ASYMAC$
[ASY_NIF2]
DRIVERNAME = ASYMAC$