User's Guide for MS-DOS Clients

232

Basic Reference

Using UNIX System Commands

Clipcach

Purpose

The clipcach command enables an MS-DOS workstation to receive network

print jobs from a server and to print these jobs on a shared printer physically

connected to the workstation, using the LaserTools PrintCache software.

This command is only available when you have a LAN Manager for UNIX

Systems server on your network.

Syntax

clipcach /i /s:driveid [any | \\servername] [ /d | /e]

clipcach [any | \\servername] [/d | /e]

where

Loads clipcach into memory. To load clipcach, use this option only after you

boot the workstation.

/s:driveid

Specifies the drive ID that clipcach will use to link to its spool directory on the

server. Replace driveid with the drive ID that clipcach is to use. To load clipcach,

use this option only after you boot the workstation. Do not add the colon after the

drive ID, for example, enter only N for driveid.

any

Allows clipcach to accept print requests from any server. Unless you specify

otherwise, any is the default when you load clipcach.

servername

Represents the name of the server from which clipcach will accept print requests.

Replace servername with the name of the server from which clipach will accept

print requests.

Temporarily disables clipcach. Network print jobs will be submitted to the queue

but will not print while clipcach is disabled. The printer can continue to be used

locally, however.