Transport Optional Upgrade Release (TOUR) 2.4 Release Notes

Patches and Fixes in This Version

8606358099 In some cases, the Traceroute command displays an

SIOCGLIFNUM ioctl failure error message, when there is a failure in

the SIOCGLIFCONF ioctl.

8606362168 In a ServiceGuard environment, a primary IPv6 interface cannot ping

a secondary IPv6 interface when the switch connecting the interfaces

is turned off and on repeatedly.

8606362712 If data is queued up on a connection that has not been "accepted"

when a disconnect arrives, a memory leak may occur that may slow

down or hang the system.

8606363701 The ndd -set ipm ip_strong_es_model 2 command succeeds

instead of displaying an error message.

8606363737 IP packets with multicast address as the source address are sent out

of the system. This violates RFC 1122 (Requirements for Internet

Hosts – Communication Layers).

8606363879 The netstat -af inet6 command takes significant amount of time

to display the output.

8606363924 Add support to enable or disable the IPv6 forwarding functionality on

a per-interface basis.

8606366305 When the netstat command is run without any options and with the

-a option, netstat does not display all the sockets’ information

properly. In addition to this, netstat does not display the address

formats (host and port) in the IPv6 section according to the output

specified in the netstat(1) manage.

8606366614 sendfile(2) returns 0 with the SIGPIPE signal if the connection

associated with the socket is closed.

8606367403 When ndd(1M) is used to retrieve information from the system, for

example, using the tcp_status parameter, ndd sometimes fails with

the following error:

ndd: Unable to initialize semaphore. Cannot print

tcp_status

8606367413 System panics with a stack trace in the nde_walk() routine.

Table 2 Transport Fixes Included in TOUR 2.4 (Continued)

SR Number Description