Transport Optional Upgrade Release (TOUR) 2.4 Release Notes

Installing TOUR 2.4

The target selection specified in the swinstall example is “TOUR” and not

“TOUR2.4” because the TOUR 2.4 product bundle name is “TOUR”. The product

bundle version reflects the version change from 2.2 to 2.4.

The TOUR 2.4 bundle contains three products: TOUR_PRODUCT, IPV6AA, and

MobileIPv6. By default, all these three products are selected to install. You can

choose not to install Mobile IPv6 and IPV6AA. However, IPv6AA is a prerequisite

for installing Mobile IPv6 and for the PPPoE/v6 functionality to function properly.

The system reboots automatically if the swinstall execution completes without

any error. If the swinstall command does not execute successfully, swinstall

displays the relevant error message and exists without installing TOUR 2.4.

NOTE To minimize the number of required reboots, you can combine patch

requirements (patch depot files) and the TOUR 2.4 software (depot file) into a

combined depot using the swcopy utility. For more information on swcopy, type

man 1M swcopy at the HP-UX prompt.

Verifying the TOUR 2.4 Installation

To verify TOUR 2.4 installation, complete the following steps:

Step 1. Examine the following log files for error messages:

• /var/adm/sw/swinstall.log

• /var/adm/sw/swagent.log

Step 2. Run the following command at the HP-UX prompt:

# swlist -l bundle TOUR

If TOUR 2.4 installed successfully, the following message is displayed:

TOUR A.02.04 Transport Optional Upgrade Release for B.11.11

Step 3. To verify that there were no errors during the TOUR 2.4 installation, run the

following command:

# swverify TOUR

If TOUR 2.4 is successfully installed, the following message is displayed:

Verification succeeded