Transport Optional Upgrade Release (TOUR) 2.2 Release Notes

Installing TOUR 2.2

Notice that, the target selection speciﬁed in the swinstall example is “TOUR” and

not “TOUR2.2”, since the TOUR 2.2 product bundle name is “TOUR”. The product

bundle version reﬂects the version change from 2.0 to 2.2.

The TOUR 2.2 bundle contains three products: TOUR_PRODUCT, IPV6AA, and

MobileIPv6. By default, these all three products are selected to install. The

MobileIPv6 and IPV6AA products are optional and may be deselected. Be aware

that the IPv6AA product is required for the MobileIPv6 product to install and for

the PPPoE/v6 functionality, which is included in the TOUR_PRODUCT, to function

properly.

The system reboots automatically if the swinstall execution completes without

errors.

NOTE To minimize the number of required reboots, you may want to combine patch

requirements (patch depot ﬁles) and TOUR 2.2 software (depot ﬁle) into one

combined depot using the swcopy utility. Refer to the swcopy(1M) man page for

more information.

Verifying the TOUR 2.2 Installation

Use the following steps after swinstall ﬁnishes installing TOUR 2.2 to verify that the

installation was successful:

Step 1. Examine the following log ﬁles for error messages:

• /var/adm/sw/swinstall.log

• /var/adm/sw/swagent.log

Step 2. Use the swlist -l bundle TOUR command.

If TOUR 2.2 installed successfully, the following message is displayed:

TOUR A.02.02 Transport Optional Upgrade Release for B.11.11

Step 3. To verify that there were no errors during the TOUR 2.2 installation, run the

following command:

swverify TOUR

If TOUR 2.2 is successfully installed, the following message is displayed:

Verification succeeded