Transport Optional Upgrade Release (TOUR) 2.0 FAQ

7. Are there any special configuration requirements for installation and operation

of this product?

No. However, note that to configure IPv6 interfaces and tunneling, you’ll need to edit the

file:/etc/rc.config.d/netconf-ipv6 (or for ephemeral changes you can use

ifconfig). Refer to the HP-UX IPv6 Transport Administrator’s Guide for TOUR 2.0

(HP-UX 11i v1) or HP-UX IPv6 Transport Administrator’s Guide for TOUR 2.0 (HP-

UX 11i v2) for more information.

8. What are the supported standards?

For a complete list of HP-UX transport-related RFCs supported in TOUR 2.0, refer to the

HP-UX IPv6 Transport Administrator’s Guide for TOUR 2.0 (HP-UX 11i v1) or HP-UX

IPv6 Transport Administrator’s Guide for TOUR 2.0 (HP-UX 11i v2).

9. How do I determine which version I am using?

Use the following command at the HP-UX command prompt:

swlist –l bundle TOUR

If TOUR 2.0 successfully installed on your system, the following message is displayed:

(on an HP-UX 11i v1 system):

TOUR A.02.00 Transport Optional Upgrade Release for B.11.11

(on an HP-UX 11i v2 system):

TOUR A.02.00 Transport Optional Upgrade Release for B.11.23

10. What are the software dependencies for this product?

There are no software dependencies for TOUR 2.0.