Transport Optional Upgrade Release (TOUR) 1.0 Release Notes

Installation Information

• Approximately, 1 MB is used in "/var".

NOTE The depot ﬁle that contains TOUR 1.0 is less than 4.5 MB.

NOTE The disk space information mentioned in this section does not include the disk

space requirements for prerequisite patches.

Conﬁguration Information

After installing TOUR 1.0, the telnet, remsh, rcp, and ftp (if WU-FTPD 2.6.1, an optional

software is installed) commands resolve addresses based on the ipnodes entry, instead of the

hosts entry.

If you have a non-default hosts entry in the /etc/nsswitch.conf ﬁle, you must conﬁgure a

similar ipnodes entry in the /etc/nsswitch.conf ﬁle for these commands, so that these

commands can resolve addresses successfully. You must perform this conﬁguration even if

IPv6 addresses are not used.

Currently, this is a known problem. For more information, see “The ipnodes Entry

Conﬁguration” on page 16.

NOTE You cannot use NIS or NIS+ on the ipnodes entry.

HP-UX 11i IPv6 Product Bundle Information

Earlier, IPv6 functionality was delivered as a web release (IPv6NCF11i) on HP-UX 11i v1.

IPv6 included in TOUR 1.0 supersedes this initial HP-UX 11i IPv6 product (IPv6NCF11i).

To enable IPv6 functionality on an HP-UX 11i v1 system, you do not have to install

IPv6NCF11i. You can obtain this functionality by installing TOUR 1.0. However, if you have

already installed IPv6NCF11i on your system, you can still install TOUR 1.0, because IPv6

included in TOUR 1.0 supersedes IPv6NCF11i.

NOTE The swlist command output will no longer display IPv6NCF11i, because

TOUR 1.0 supersedes IPv6NCF11i.