TOUR Transition Release Notes (September 2004)(11i v1 and 11i v2)

Transport Optional Upgrade Release Transition Release Notes

Installing the Transition Patches

Step 3. Run the swinstall command:

swinstall -x autoreboot=true -s /tmp/COMBO.depot

The system reboots automatically if the swinstall installation completes without

any errors.

Installing the Transition Patches on HP-UX 11i v2 September 2004

If your HP-UX 11i v2 September 2004 system has TOUR installed, the cumulative Transport

and STREAMS patches will clean TOUR from your system.

NOTE The IPv6 enablement and functionality, PPPoE/PPPv6 functionality and

upgrade, Router Advertisement Daemon, Mobile IPv6 products are present on

the base HP-UX 11i v2 September 2004 release.

Perform the following steps to install the transition patches on an HP-UX 11i v2 September

2004 system:

Step 1. If you require the IPSec functionality, download IPSec A.02.01.01 from

http://www.hp.com/go/softwaredepot. Search for IPSec.

Step 2. swcopy the following into a single installation bundle called COMBO.depot:

• Transition Patches and their dependencies: described in “Downloading the

Transition Patches and Dependencies” on page 21

• IPSec A.02.01.01: if you require IPSec functionality

See the swcopy man page for more details.

Step 3. Run the swinstall command:

swinstall -x autoreboot=true -s /tmp/COMBO.depot

The system reboots automatically if the swinstall installation completes without

any errors.

Verifying the Transition Patch Installation

Complete the following steps to verify the transition patch installation on your system: