PCI Token Ring Quick Configuration Guide

netstat -r command.

Successful? If the routing tables are not correct, refer to the route man page.

Refer to the on-line manual pages for more detailed information about the

commands listed in the above steps.

If you are still having problems connecting your system to the network, contact

your HP support representative.

Reference Information

NOTE: Only those items with an “X” in the “*” column are possible prior to conﬁguration.

Bulkhead Detail

Status LEDs

* Amber -

Error

Green -

Link

Explanation

X Blinking Blinking The adapter is waiting for initialization.

Off Off The adapter initialization is in progress or the system is not powered on.

Off Blinking The adapter did not detect any problems during self-diagnostic tests and is waiting to open.

NOTE: If this state occurs after the adapter has been opened, this indicates that the adapter has been closed via software

control / cable disconnect.

Off On The adapter is open/operating correctly.

X On Off The adapter self-diagnostic tests failed or there is a problem with the adapter.

Blinking Off The adapter is closed due to an undetected error. One of the following is possible:

. The adapter open failed.

. The adapter detected a wire fault.

. The adapter failed auto-removal test.

Blinking On The adapter has detected beaconing or a hard error.

X On On The adapter has failed before running its self-diagnostics.

Green LED

9-pin

D-shell Connector

Amber LED

Use RJ-45 OR 9-pin connector.

(but never both)

RJ-45 Connector