PCI FDDI Administrator's Guide

Installing and Configuring PCI FDDI
2 - Load the Software
Chapter 2 49
2 - Load the Software
Follow the steps below to load PCI FDDI software using the HP-UX
swinstall program. See the note at the end of this section for
information on unloading the PCI FDDI software.
NOTE The PCI FDDI software is part of the HP-UX software bundle and is
located on the HP-UX Application Release (AR) CD.
1. Log in as root.
2. Insert the software media into the appropriate drive.
3. Run the swinstall program using the command:
/usr/sbin/swinstall
This opens the Software Selection Window and Specify Source
Window.
4. Change the Source Host Name if necessary, enter the mount point of
the drive in the Source Depot Path field, and activate the OK button
to return to the Software Selection Window. Activate the Help button
to get more information.
5. Highlight the appropriate product specific software.
6. Choose Mark for Install from the “Actions” menu to choose the
product to be installed.
7. Choose Install from the “Actions” menu to begin product installation
and open the Install Analysis Window.
8. Activate the OK button in the Install Analysis Window to confirm
that you want to install the software. swinstall displays the Install
Window.
• swinstall loads the fileset, runs the control scripts for the
filesets, and builds the kernel. Estimated time for processing: 3
to 5 minutes.
• View the Install Window to read processing data while the
software is being installed. When the status field indicates ready,
the Note Window opens.