PCI FDDI Administrator's Guide

Troubleshooting PCI FDDI

Diagnostic Flowcharts

Chapter 3106

Flowchart 5c Procedures

• Execute ifconﬁg on the interface you want to conﬁgure to ensure that

interface is enabled. Example:

ifconfig lan1 192.6.1.17 255.255.255.0 up

Next, ifconﬁg <interface> to test and verify the ﬂag setting is UP and

the correct IP address is displayed. Example:

ifconfig lan1 <UP,BROADCAST,RUNNING,MULTICAST,CKO>

• If the IP and ﬂags are correct, verify there is an entry for the PCI

FDDI adapter interface in /etc/rc.config.d/netconf. If so,

continue to the Network Level Test. Otherwise, add the correct

interface parameters to /etc/rc.config.d/netconf ﬁle and

reboot. If the ﬂags are incorrect, correct them with ifconﬁg and

repeat the ifconﬁg Test. Otherwise, if the ifconﬁg command is

unsuccessful and error messages appear, correct them accordingly

and repeat the ifconﬁg Test.

• If you cannot correct the errors, call HP.