NIO CommKit Host Interface Installation and System Administration Manual

2-8
Installing the NIO CommKit Host Interface
Updating the VCS Database
Use the following as an example:
GROUP: hpams5x
TYPE: local
DIRECTION: 2way
DEVICE or HOST: hpams5x
PASSWORD:
anything you like
ROUND ROBIN SERVICE: <return>
4 Press Delete (or Shift-Escape) to return to the CCO> prompt.
Entering the CommKit Server Address
1 At the CCO> prompt, type:
CCO> enter address
2 Answer each of the database prompts that appears, pressing Return to accept the
default value or entering one of the other allowed values. Use the following as an
example:
LEVEL: local
TYPE: mnemonic
MNEMONIC ADDRESS: hpams5x
PAD SUPPORT: <return>
DIRECTORY ENTRY: <return>
GROUP: hpams5x
ORIGINATING GROUP NAME SECURITY PATTERN: <return>
INITIAL SERVICE STATE: in
3 Press Delete (or Shift-Escape) to return to the CCO> prompt.
Entering the STREAMS Listener Address (Optional)
Follow the steps in this section only if you use a STREAMS listener.
1 At the CCO> prompt, type:
CCO> enter address
2 Answer each of the database prompts that appears, pressing Return to accept the
default value or entering one of the other allowed values. Use the following as an
example:
CCO> enter address
LEVEL: local
TYPE: mnemonic
MNEMONIC ADDRESS: HPAMS5X
PAD SUPPORT: <return>
DIRECTORY ENTRY: <return>
GROUP: hpams5x
ORIGINATING GROUP NAME SECURITY PATTERN: <return>
INITIAL SERVICE STATE: in
Note that you enter the Mnemonic Address in all uppercase characters.
3 Press Delete (or Shift-Escape) to return to the CCO> prompt.