NIO CommKit Host Interface Installation and System Administration Manual

DKERR(3X) DKERR(3X)

E-49 CommKit Host Interface, Release 4.0

1035 No initial dial tone detected

The autodialer on the called port possibly has a bad telephone line. The port has been marked as bad

and removed from the autodialer hunt group.

1291 No secondary dial tone detected

The autodialer was signaled to wait for a secondary dial tone in the dialing sequence and no such

dial tone was detected.

1547 Dialed number is busy

The call was successfully dialed and a busy signal was detected by the autodialer.

1803 No answer from dialed number

The call was dialed successfully and the autodialer didn’t get an answer from the dialed number.

2059 No carrier tone was detected

The call was dialed successfully and answered, however, no carrier tone was detected by the

autodialer.

2315 Could not complete your call. Try again.

The call could not be completed for the following possible reasons: 1) the autodialer failed to

complete the dialing sequence, or 2) the port connected to the autodialer was removed from service

during the call.

2571 Unsupported baud rate

The requested baud rate is not supported by the dialer.

FILES

/usr/lib/libdk.so host interface subroutine library