NIO CommKit Host Interface Installation and System Administration Manual

DKERR(3X) DKERR(3X)
E-48 CommKit Host Interface, Release 4.0
The following messages result from a disconnected call.
50 hupEPOINT Endpoint hung up
The endpoint hung up the call. This is not an error.
51 hupNETWORK Network hung up
The network hung up the call.
52 hupSPLICE Splice completed
53 hupSPLICE_FAIL Splice failed
The following errors come from dkserver(1M).
130 EdDEVBAD Dkserver: Can’t open line. Call System Administrator
The call could not be completed because the host server could not open the host device to make the
call.
131 EdMODPUSH Dkserver: Can’t push your streams modules
The configured STREAMS modules could not be pushed onto the open channel.
132 EdBADPROTO Dkserver: Invalid protocol requested
The host does not recognize the data switch control computer protocol.
133 EdNOSRVTAB Dkserver: Srvtab not readable. Call System Administrator
The call could not be completed because the host server table (located in /etc/opt/dk/srvtab) on the
remote host was unreadable.
134 EdBADCHROOT Dkserver: Can’t chroot. Call System Administrator
The call could not be completed because the host server could not change root to the home directory
of the caller on the remote machine.
135 EdOPTION Dkserver: Can’t set/get circuit parameters. Call System
Administrator
The call could not be completed because the remote dkserver(1M) failed to either set the
originator’s receive buffer size and URP initialization code, or it failed to get the receive buffer size
for the receiving channel.
136 EdNOTIDLE Dkserver: Call on a busy device or call collision, try again
The call could not be completed because the remote data switch server detected that the device was
not idle. This results from a busy device or from a call collision on the remote host. This is a
temporary load related condition.
The following error is returned by the library function.
150 EdBADPARAM Bad parameter
A dkdial(3X) routine was called with an invalid parameter.
The following errors come from the old autodialer.
267 Please supply a valid phone number
The user has neglected to type the phone number required to make a phone call as in dial. <valid-
phone-number>
. The phone number is synonymous with the dialstring.
523 No response from autodialer. Try again.
The autodialer on the called port failed to respond. The port has been marked as bad and removed
from the autodialer hunt group.
779 Auto dialer failed to initiate call. Try again.
The autodialer on the called port responded but failed during dialing. If this message appears more
than twice in succession, contact the data switch Network Administrator.