NIO CommKit Host Interface Installation and System Administration Manual

C-2

Ordering Information

AT&T Fiber Optic Cables

The cable required to connect a CommKit interface board to a CPM-HS

module in an AT&T data switch is a 62.5 micron ﬁber optic cable with

AT&T’s split-ferrule straight-tip (ST) connector on both ends.

You may refer to the required cables by name as FL2P-P and by letter code

as HH. You can order them from AT&T in various lengths, as shown in

Table 6. The information in the table is based on the AT&T Datakit II VCS

Release 2.1 Cabling Guide (255-111-606, issue 2).

Table 6 AT&T Fiber Optic Cables

Cable Length

(in feet)

Code

2 104266408

4 104266476

6 104266424

8 104266432

10 104266440

15 104266457

20 104266465

25 104266473

30 104266481

35 104266499

40 104266507

50 104266523

75 104266556

100 104266564

200 104266606