NIO CommKit Host Interface Installation and System Administration Manual

B-22
Troubleshooting Guide
Other CommKit Error Messages
Explanation You may be using an older version of the data switch
software.
Action Check the data switch software, and make sure that you
are using the latest release.
dkserver: Can’t open lock file -- /var/opt/dk/log/dk.1.hpwrcxv
Explanation You have issued an incomplete dkserver -t command to
stop a running CommKit server with more than one
CommKit interface board installed.
Action You must use both the -s servername and -i interface
options with dkserver -t to specify the server name and
interface board number you want to stop.
LISTEN: TLI t_bind failed: Incorrect address format
Explanation The listener name was not entered in the data switch
database.
Action Verify the data switch database to make sure the listener
name is entered correctly.
Explanation The host server name does not match the server address
entered in the data switch database.
Action Verify the data switch database to make sure the server
address is correct for the host name.
LISTEN: TLI t_bind failed: System error: Interrupted system call
Explanation The fiber optic cable connections are bad.
Action Verify that the fiber optic cables are connected correctly.
Explanation The CPM-HS module is out of service on the data switch.
Action Verify that the CPM-HS module is in service. If not, run
restore cpm on the data switch to bring the CPM-HS
module into service.
Explanation The CPM-HS module is faulty.
Action Check the data switch. If the fault light is on, indicating