NIO CommKit Host Interface Installation and System Administration Manual

B-13
Troubleshooting Guide
Outgoing Call Error Messages
may be due to improper configuration of dkdaemon on the
machine you are calling. See the dkdaemon(1M) manual
page for more information on the -x option.
You may also see this error message on an incoming call
from a
DESTINATION prompt displayed as error code
130.
dkdial ... Dkserver: Can’t push your streams module
Explanation The call could not be completed, because the configured
STREAMS modules could not be pushed onto the open
channel.
You may also see this error message on an incoming call
from a
DESTINATION prompt displayed as error code
131.
dkdial ... Dkserver: Can’t set/get circuit parameters: Call System
Administrator
Explanation The call could not be accepted, because the dkserver
process could not communicate with the host device.
Either the incoming initialization or buffer size could not
be set or the receiving buffer size could not be returned in
the answer.
You may also see this error message on an incoming call
from a
DESTINATION prompt displayed as error code
135.
dkdial ... Dkserver: Invalid protocol requested
Explanation The call could not be completed, because the remote
server did not understand the connection protocol.
You may also see this error message on an incoming call
from a
DESTINATION prompt displayed as error code
132.