NIO CommKit Host Interface B.04.20.03 Release Notes

8 Chapter1
NIO Commkit Release Notes
Compatibility and Installation Requirements
Installing the Software and/or manpages
The NIO Commkit Host Interface software can be installed using the command:
swinstall -x autoreboot=true -s [software source] Z7126A
Where[softwaresource]isusuallythedevicespecialfileoftheDDStapeortheCD-ROM
mount point containing the software.
Note that the product has k ernel components and the swinstall procedure will modify the
/stand/system file, rebuild the kernel and reboot the system. It will also run the scripts to
configure the product. However, if errors are generated during configuration after boot,
product configuration can be rerun as a separate command:
swconfig Z7126A
See the manual NIO Commkit Host Interface, Installation and System Administration
Manual, Release 4.0 for HP_UX 10.x, part number Z7126-90005, for additional information.
Users wanting to install only the man pages for the NIO Commkit Host Interface product can
install the man pages using the command:
swinstall -s [software source] Z7126A.DK4NIO.DKIT4-MAN
Hardware Requirements:
• The NIO Commkit Host Interface product runs only on Series 800 computers having an
NIO backplane.
• The NIO Commkit Host Interface product includes one N IO Datakit interface, part
number 93302-60010. Up to eight (8) Datakit cards may be installed in the computer's card
cage.
• Additional interfaces may be ordered using product number Z7127A.
Operating System Platform Requirements:
HP-UX 10.20.
Disk Space and Me mory Requirements:
.