NetWare 4.1/9000 Utilities Reference

3-80
Server Utilities
rrouter
rrouter
Purpose
Use at the HP-UX prompt to reset and rebuild the IPX Router table in
NetWare services by requesting route information from all neighboring
routers.
Syntax
rrouter
Using rrouter
• You must be the root user to use rrouter.
• This command is normally not needed during the operation of the IPX protocol
stack.
However, if a router has crashed, it might take several minutes before its routes
are removed from the routing table. Running rrouter could speed up the process.
• Running rrouter might cause a momentary increase in the amount of RIP traffic
on the network.