NetWare 4.1/9000 Utilities Reference

3-26
Server Utilities
nwcm
Table 3-1 General Server Parameters
Parameter Use to
alert_notify_string=
value
Specify a list of users who are to receive alert
messages in addition to ADMIN. Enclose the
list of usernames within single quotation
marks. A semicolon should immediately
follow each username. For example, to send
alert messages to users Larry and Judy, the
alert list should contain ‘Judy;Larry;’.
Maximum length: 127
Default: Not Configured
burst_mode_clients=
number
Limit the number of clients that can use the
Packet Burst protocol. The server allocates a
buffer in shared memory for the private use
of each Packet Burst client.
If you allow all clients to use Packet Burst,
you may need to increase the size of shared
memory. When this parameter is set to zero,
all clients can use the Packet Burst protocol.
Supported values: 0 to 1000
Default: 0
burst_mode_protocol=
value
Determine whether NetWare clients can use
the Packet Burst protocol. The Packet Burst
protocol reduces traffic by allowing a burst
of packets to be acknowledged with one
packet (rather than acknowledging each
packet.)
If set to Yes, Packet Burst is enabled. Use the
burst_mode_clients parameter to specify
how many clients can use the protocol.
Supported values: Yes, No
Default: Yes