NetWare 4.1/9000 Print Services

2-51
Managing Print Services with the NetWare Administrator Utility
Working with Print Job Configurations
Choose “Text” when you want tabs to be converted to spaces. Also choose
“Text” to print ASCII text.
Choose “Byte stream” if you are printing from within an application and you
want the application to handle the formatting commands. Also choose “Byte
stream” if you will be downloading fonts on a laser printer.
• “Tab Size” is the width in characters that each tab character should be
expanded to. This field is only available if you select “Text” in “File
contents.”
• “Form Feed” determines whether a form feed is sent when a job is completed.
• “Notify When Done” determines whether a message is sent to the workstation
of the print job originator when the job has finished printing.
• “Local Printer” specifies which of your computer’s parallel ports will be
captured. The values listed are LPT1 through LPT9.
• “Auto end cap” determines if the CAPTURE command automatically ends
when a print job is completed.
• “Printer/Queue” allows you to select the Printer or Queue object that the print
job configuration should use. The “Select Object” dialog appears when the
browser button is selected.
• “Device” allows you to select which print device definition this print job
configuration uses.
• “Mode” allows you to select the mode this print job configuration uses. The
modes listed are defined by the device definition you selected.
• “Form Name” allows you to select which printer form this print job
configuration uses.
• “Print Banner” determines if this print job configuration includes a banner
page at the beginning of each print job. If this check box is selected, the next
two fields are available.
• “Name” identifies the user who sent this print job. This is only valid if a
banner page is printed.
• “Banner Name” indicates the name of the print job. This is only valid if a
banner page is printed.
• “Enable timeout” determines if each print job will time out after a specified
period of time. If this is selected, “Timeout Count” can be set.
• “Timeout Count” field is the number of seconds that must pass without
data being sent to the queue before the print job is closed. You must select