NetWare 4.1/9000 Print Services

7-9
Creating and Managing Print Job Configurations
Working with Print Job Configurations
Local printer This parameter is used only with CAPTURE. You can specify which local
parallel printer port (LPT1, LPT2, or LPT3) you want to capture.
Default: LPT1
Auto endcap This parameter is used only with CAPTURE. Type “Y” for “Yes” or “N”
for “No.”
Choose “Yes” if you want the captured data to be printed when you exit an
application or when the application closes the printer.
Choose “No” if you don’t want the captured data to be printed until you
issue a CAPTURE EC command. An alternative is to add TI=number to
your CAPTURE command.
Default: Yes
Enable timeout This parameter is used only with CAPTURE. Type “Y” for “Yes” or “N”
for “No.”
Choose “Yes” if you want the captured data to be sent to the queue after the
number of seconds you define as the “Timeout count” has elapsed since
receiving data.
Default: No
Timeout count Specifies the number of seconds the operating system should wait after the
last data is received before closing the print job.
If your timeout is not long enough, you may have problems printing some
files, especially files with graphics. Increase the timeout if only parts of
files are being printed or if the files do not print at all.
Default: 5
Printer/Queue Indicates to which printer or print queue the print job should be sent.
Bindery mode uses only queue names.
Device Press <Enter> to see a list of print devices defined in PRINTDEF you can
use.
Mode Press <Enter> to see a list of the modes for the print devices you chose. A
mode is a set of control sequences defined in PRINTDEF.
Table 7-1 PRINTCON Configuration Parameters
Parameter Explanation