J2120B DTC Manager/UX Version A.14.4J.110 for HP-UX

Chapter 1 7

J2120B DTC Manager/UX Version A.14.4J.110 for HP-UX 11.11 Release Note

Compatibility and Installation Requirements

CAUTION To update from another version of DTC Manager/UX, you must ﬁrst upgrade to

HP-UX 11.00 and install DTC Manager/UX version A.14.4J.000. Then upgrade

to HP-UX 11.11, and install DTC Manager/UX version A.14.4J.110.

DTC Conﬁguration Migration

To migrate from one system to another, transfer the DTC conﬁgurations to the new HP-UX

11.11 system where DTC Manager/UX version A.14.4J.110 is already installed.

Migration is supported from the following versions of the DTC Manager/UX on the source

system:

• A.14.4C.020 running on HP-UX 10.20

• A.14.4J.000 running on HP-UX 11.00

• System already running A.14.4J.110 on HP-UX 11.11

To migrate the DTC conﬁgurations onto the target system running HP-UX 11.11:

1. Use dtcexport for each DTC on the source system, so an .exim ﬁle is generated for each

DTC conﬁguration.

The directory for .exim ﬁles is; /var/opt/dtcmgr.

2. Use dtcdisown for each DTC on the source system.

Caution: A DTC can’t be managed by two systems simultaneously.

3. Copy the .exim ﬁles onto the target system, under the /var/opt/dtcmgr directory.

4. Run the dtcimport command for each DTC on the target system.

5. Use dtcown for each DTC.

6. Cycle power on all the migrated DTCs.

Refer to Using the HP DTC Manager/UX (J2120B-62000) and/or the man pages for the

dtcexport, dtcdisown, dtcimport and dtcown commands.