Installing and Administering HP FDDI/9000 Software

62 Chapter 4
Troubleshooting HP FDDI/9000
Diagnostic Flowcharts
H. Is driver in kernel? If yes, go to J. If no, the driver
has not been generated into the kernel and the ioscan -f
output will look like the following. Go to I.
I. Regen kernel with driver. See your system’s System
Administration Tasks manual for instructions on how
to create a new kernel. Then go to L.
J. Is device adapter displayed? If the device adapter is
broken, no entry for the hardware path in which the
adapter is inserted will be displayed. Go to L.
K. Check hardware. Verify that the network adapter is
seated correctly and that it is operational. Go to L.
L. Problem fixed? If you have found and corrected the
FDDI adapter problem, stop. If not, start again with
Flowchart 2. If the problem still exists after two
iterations, call your HP representative.
Class I H/W Path Driver S/W Status H/W Type Description
===============================================================
lan 0 48 fddi CLAIMED INTERFACE HP J2157A - FDDI
lan 1 56.1 lan3 CLAIMED INTERFACE
Class I H/W Path Driver S/W Status H/W Type Description
================================================================
unknown - 48 ? - - -