Installing and Administering HP FDDI/9000 Software

Chapter 3 45

Conﬁguring HP FDDI/9000

Conﬁguring the Local FDDI Adapter

d. Specify whether your FDDI card will be on a subnetwork.

If you choose YES, enter the subnet mask for your subnetwork.

e. Optionally, enter comments about your FDDI card.

f. Choose Add Aliases for Internet Address to open the Add Aliases

window.

NOTE You must complete this step if you have more than one Fibre Channel

card installed in your system.

g. Add, modify, or remove alias names for your FDDI card.

h. Activate the OK button to perform the task and return to the

Conﬁgure LAN Card window.

7. Activate the OK button at the Conﬁgure LAN Card window to enable

your FDDI card.

NOTE If the software is correctly conﬁgured, SAM displays the Network

Interface Cards object list with the status Enabled for your FDDI card;

otherwise, SAM displays an error message.

8. At the Networking and Communications window, choose Exit SAM

from the “File” menu.

NOTE If you have moved or removed any FDDI cards from the system, HP

recommends that you verify the IP address of every card in the

backplane before leaving SAM.

9. Go to the next section, “Verifying the Installation.”