9000

44 Chapter 3

Installing the HP HSC FDDI/9000 Adapter

Installing the Adapter

Installing the HSC FDDI Adapter on K and

T-600 Systems

The HSC FDDI adapter may be installed on either the HSC Expansion

I/O card or on the Core I/O card. All K class systems have a Core I/O card

already installed. Some systems also have an HSC Expansion I/O card

installed.

NOTE The following steps should be done while wearing a grounding strap.

1. Determine whether you will install the HSC FDDI adapter on the HP

9000 Core I/O card or the HSC Expansion I/O card. Figure 3-1 shows

a system that contains both cards. The Core I/O card provides one

adapter slot. The HSC Expansion I/O card provides four adapter

slots. If the system does not have an HSC Expansion I/O card, install

the adapter on the Core I/O card.

Figure 3-1 System with Core I/O and HSC Expansion I/O

2. Remove the Core I/O or the HSC Expansion I/O card from the system

by unscrewing the two screws on either end of the card which secure

the card in the system. Unscrew the screws until they pop out.

Core I/O

HSC Expansion I/O