HP-UX TN3270 Users Guide, March 1998

Appendix C 297
File Transfer Messages
Menu Interface File Transfer Messages
Menu Interface File Transfer Messages
This section describes the file transfer messages generated during file
transfer processes initiated from the menu interface. These messages are
displayed in the File Transfer dialog box.
Completed successfully
The operation is complete; no action is required.
Error - host initiated transfer in screen mode
The host configuration is incorrect—the host attempted to start a file
transfer process in screen mode, which the TN3270 emulation program
cannot support. Use the Control Display Sessions dialog to disable the
session (this is the only way to clear the condition), and then report the
problem to your System Administrator.
File transfer aborted by user
You canceled the transfer operation. No action is required. (This message
occurs if you cancel the file transfer before the host has accepted your file
transfer request or after the host has completed it.)
File transfer could not be started due to lack of local
resources
The TN3270 emulation program cannot allocate enough memory for the
data buffer needed for a file transfer process (generally because too many
other processes are running at the same time). Retry when other file
transfer processes have finished or when there are not so many users on
the system. If this problem occurs repeatedly, contact your System
Administrator.
General I/O fault
The HP-UX computer has a problem reading or writing. Retry the
operation. If unsuccessful, contact your System Administrator or
technical support.
Number of bytes transferred: nn
Information message, after completion of the file transfer command.
Not allowed to delete the specified local file