HP-UX TN3270 Users Guide, March 1998

Chapter 5 157
Transferring Files
Transferring Files from the HP-UX Command Prompt
Optional. The session ID of an active 3270 display
session, specified as a hexadecimal value. If the
session's ID was specified using the -h option when
starting the TN3270 emulation program and is not in
the range A–Z, you must specify it using this option; if
the session ID is in the range A–Z, you can either use
SESSIONID: or this option. Only one of these
parameters can be specified.
HP-UX filename
The name of the HP-UX file sent to the host or the
HP-UX file receiving data from the host. Specify any
valid HP-UX file name, with or without a path.
SESSIONID:
Optional. Either the one-character session ID (in the
range A–Z) or the long name of an active 3270 display
session. The ID must be in uppercase characters and
followed by a colon. The session must have a session ID
assigned, even if you use the long name. For
information about assigning session names and IDs,
see Chapter 6, “Customizing 3270 Emulation.”
If the session's ID was specified using the -h option
when starting the TN3270 emulation program, you
must specify it using the -h option in the command and
not using SESSIONID:. Only one of these parameters
can be specified.
If neither SESSIONID: nor -h 0xnn is specified, the
program tries to use the session configured with the
lowest hexadecimal value for its session ID.
datasetname
MVS/TSO only: required. The name of the host data
set to which a named HP-UX file is sent, or the name of
the host data set from which data is received. If you
specify a fully qualified data set name (that is, the first
element of the name is a user ID), enclose the data set
name in single quotation marks; the membername
parameter, if used, must also be inside the quotation
marks.
\(membername\)