Support Plus User Guide HP-UX 11i Version 1, September 2003

Support Plus User Guide HP-UX 11i v1
Setting Up Access to Support Plus
Chapter 1 21
Setting Up Hard Disk Access
If more than two systems must access the depot, or if you cannot dedicate
the CD drive to the Support Plus CD, HP recommends that you copy the
patch depots to a hard disk using the swcopy command.
For example, with the CD mounted at /
cdrom , enter
swcopy -s /
cdrom /HWEnable11i \* @ /var/tmp/MyDepot
This command copies the contents of the HWEnable11i depot to the local
system under the /var/tmp/MyDepot directory. The new depot is
registered automatically for remote systems to use.
Notes •If the swcopy interactive user interface appears, then you may need
to enter additional information.
• HP recommends that you do not merge depots created on different
versions of HP-UX. Also, HP recommends that both the host system
and depot should have the same major HP-UX version, for example,
HP-UX 11.x versions.
HP-UX 11.x encompasses the HP-UX 11.0 and 11.11 versions.
Preparing Your Systems for ISEE Support
Before installing Instant Support Enterprise Edition, verify that you
have met all of the requirements outlined in Chapter One of Getting
Started with HP Instant Support Enterprise Edition for the Standard
Configuration.