Software Distributor Administration Guide for HP-UX 11i

Command Options
Options Listed Alphabetically
Appendix A 447
• os_name
Specifies fileset selection for an HP-UX update. (This option should
always be used with the os_release option.) You must specify this
option from the command line or when invoking the swinstall GUI.
This options has the following syntax:
os_name = operating_system :width
— operating_system specifies the name of the operating system,
such as HP-UX. See the
uname (1) manual page for complete
information.
—
width specifies the word width in bits (either 32 or 64) of the OS
to be installed.
—
operating_system and width must be separated by a colon (:).
Applies only to swinstall.
• os_release
Specifies fileset selection for an HP-UX update. (This option should
always be used with the os_name option.) You must specify this
option from the command line or when invoking the swinstall GUI.
This options has the following syntax:
os_release=
release
release
specifies the HP-UX release. Values include:
B.10.01
B.10.10
B.10.20
B.10.30
B.11.00
Applies only to swinstall.
• package_in_place=no
Setting this option to yes causes swpackage to build the products
such that the depot does not actually contain the files that make up a
product. Instead, the depot references the original source files used
to build a product. This lets you package products in a development
or test environment without consuming the extra disk space required
to create a distribution depot.
Applies only to swpackage.