Software Distributor Administration Guide for HP-UX 11i

Creating Software Packages
Packaging the Software (swpackage)
Chapter 10352
-S
session_file
Run the command based on values saved from a
previous installation session, as defined in
session_file . See “Session Files” on page 61.
-x
option=value
Sets a command
option to value and overrides default
values or a values in options files. See “Changing
Command Options” on page 353.
-X
option_file
Read session options and behaviors from
option_file .
See “Changing Command Options” on page 353.
software_selections
The software objects to be installed. See “Software
Selections” on page 56.
If you do not include this specification, swpackage
packages all the products listed in the PSF.
@
target_ selections
The target of the command. See “Target Selections” on
page 58.
If you are creating a distribution depot (directory), this
operand defines the location of the
directory . Without
this operand, /var/spool/sw is used as the default
depot directory.
If you are creating a distribution tape, this operand
names the
device file on which to write the tar
archive. swpackage must be able to determine if the
media is a DDS tape or a disk file. Without this
operand, swpackage uses the device file, /dev/swtape.