Software Distributor Administration Guide for HP-UX 11i

SD-UX Security
The swacl Command
Chapter 9 259
-t
target file
Reads a list of target host selections from a separate
file instead of from the CLI. (See “Target Files” on
page 59.)
-x
option=value Lets you change an option on the command line
interface (CLI) that overrides the default value or a
value in an alternate options file (-X
option file ). See
“Changing Command Options” on page 259.
-X
option file Uses the option values in a specified option file . See
“Using Command Options” on page 59.
software_selections
The software objects for the swacl operation. See
“Software Selections” on page 56.
target_selections
The target of the command. See “Target Selections” on
page 58.
Changing
Command Options
You can change the behavior of this command by specifying additional
command-line options when you invoke the command (using the -x
option) or by reading predefined values from a file. The following table
shows the defaults and options that apply to swacl.
For More
Information
See Appendix A, “Command Options,” on page 421 for complete
descriptions of each default.
Table 9-2 swacl Command Options and Default Values
• admin_directory=/var/adm/sw
• distribution_target_directory=
/var/spool/sw
• installed_software_catalog=produc
ts
• level=
• log_msgid=0
• rpc_binding_info=ncacn_ip_tcp:[21
21] ncadg_ip_udp:[2121]
•rpc_timeout=5
• run_as_superuser=true
• select_local=true
•targets=
•verbose=1