Software Distributor Administration Guide for HP-UX 11i

Using Jobs and the Job Browser
Monitoring Jobs from the Command Line
Chapter 7 231
-t
target_file
Read a list of target selections from a separate file
instead of (or in addition to) those you specify on the
command line. See “Target Files” on page 59.
-x
option=value
Sets a command
option to value and overrides default
values or a values in options files. See “Using
Command Options” on page 59.
-X
option_file
Read session options and behaviors from
option_file .
See “Using Command Options” on page 59.
jobid One or more identification numbers for an SD-UX
operation. You can read job ID numbers from the Job
Browser when you set up or monitor your jobs
interactively.
target_selections
The target of the command. See “Target Selections” on
page 58.
Changing
Command Options
You can change the behavior of this command by specifying additional
command-line options when you invoke the command (using the -x
option) or by reading predefined values from a file. The following table
shows the defaults and options that apply to swjob.
For More
Information
See Appendix A, “Command Options,” on page 421 for more information
about setting options and a complete listing and description of each
option.
Table 7-3 swjob Command Options and Default Values
• admin_directory=/var/adm/sw
• agent_timeout_minutes=10000
• log_msgid=0
• one_liner={jobid operation state
progress results title}
• rpc_binding_info=
ncacn_ip_tcp:[2121]
ncadg_ip_udp:[2121]
•loglevel=1
• match_target=false
•rpc_timeout=5
• run_as_superuser=true
•targets=
•verbose=1