Software Distributor Administration Guide for HP-UX 11i

Remote Operations Overview
Remote Operations Tutorial
Chapter 6202
Step II:
Select Targets
The Target Selection Window displays the local, default target. A target
is where you want the installation to go (in the example below, the target
is the system swbash3). By default, the current system is listed
(Figure 6-3, “Target Selection Window,”).
Figure 6-3 Target Selection Window
Specify the desired target for the installation:
1. For local default:
a. Highlight the local target system with a left mouse click. Then
select
Actions→Mark for Install (or right-click to display the pop-up
menu and select
Mark for Install).
b. Select
Actions→Show Software for Selection...
This displays the Specify Source dialog. If this is your first time
through this tutorial, skip directly to “Step III: Select Source” on
page 204. After you have gone through this tutorial once, retry Step I
using remote targets.