Software Distributor Administration Guide for HP-UX 11i

Remote Operations Overview
Remote Operations Tutorial
Chapter 6 201
How to Perform a Single-Target Installation
Overview The tutorial consists of these steps:
Step I: Start-up To initiate an install session:
1. Start the Job Browser by typing:
sd
2. From the Job Browser window, choose
Actions→Create Job→Install Software...
The message Invoking a swinstall process displays at the
bottom of the window, then the Target Selection Window appears.
Table 6-2 Installation Steps
Overview of Installation Steps
I. Start-up Start the Job Browser.
II. Select
Targets
Specify the targets where you want the software
installed. You can use the default local target or
specify another target.
III. Select
Source
Provide the location of the software depot from
which the software will be installed with the
Specify Source dialog.
IV. Select
Software
Use the Software Selection Window to select the
software to install.
V. Specify
Install
Preferences
Use the Install Preferences dialog box to set
preview or scheduling options.
VI. Analysis
and
Installation
Perform the actual software installation or
preview.
VII. Monitor
Results
Monitor job progress and results using the Job
Browser GUI.
VIII. Remove
Jobs
Delete the completed jobs using the Job Browser.