Software Distributor Administration Guide for HP-UX 11i

Remote Operations Overview
Using the Remote Operations GUI
Chapter 6 195
4. When you have selected all targets for your operation, select
Actions→Show Software for Selection.... to display the Software
Selection Window.
Selecting Multiple Targets
This section discusses how to install to multiple targets, create target
groups, and how to save these groups for future software installations.
(For single-target installations to your local (default) target, see the
procedures in “Remote Operations Tutorial” on page 200).
The Target Selection Window displays a list of targets may be displayed:
• If you have recalled a session file (
File→Recall Session), any hosts
defined in that session are displayed.
• Otherwise, any hosts specified in the default hosts file
(/var/adm/sw/defaults.hosts or $HOME/.sw/defaults.hosts)
are displayed. (See “Preselecting Host Files” on page 39.)
• If you started SD-UX from ServiceControl Manager, targets are
pre-selected and cannot be changed.
If the desired target for the installation is not in the list:
1. Choose
Actions→Add Targets.... The Add Targets dialog (Figure 6-2,
“Add Targets Dialog,”) is displayed.
Figure 6-2 Add Targets Dialog