Software Distributor Administration Guide for HP-UX 11i

Managing Installed Software
Removing Installed Software (swremove)
Chapter 3128
Removing with the Command Line
Syntax swremove [ XToolkit Option ][-d|-r] [-i] [-p] [-v]
[-C
session_file ][-f software_file ][-Q date ] [-s source ]
[-S
session_file ] [-t target_file ] [-x option=value ]
[-X
option_file ] [ software_selections ][@ target_selections ]
Options and
Operands
XToolkit Options X window options for the GUI. See “XToolkit Options
and Changing Display Fonts” on page 53.
-d Operates on a depot rather than installed software.
“Removing Software from Depots” on page 162 for more
information.
-i Runs a GUI or TUI interactive session. Used to
“pre-specify” software selections for use in the
GUI/TUI.
-p Preview an install task by running it through the
Analysis Phase and then exiting.
-r Operate on an alternate root directory.
-v Turn on verbose output to stdout and display all
activity to the screen.
-C
session_file
Run the command and save the current option and
operand values to a session_file for re-use in another
session. See “Session Files” on page 61.
-f
software_file
Read a list of software selections from a separate file
instead of (or in addition to) the command line. See
“Software Files” on page 58.
-Q
date Schedules a job for the given date when remote
operations are enabled. See “Scheduling Jobs from the
Command Line” on page 234 and Chapter 6, “Remote
Operations Overview,” on page 189
-S
session_file
Run the command based on values saved from a
previous installation session, as defined in
session_file . See “Session Files” on page 61.